Forums » CircuitLab Support Forum

I am looking at using CircuitLab to teach circuits in an introductory physics class. We are only using DC circuits and resistor combinations at this time. Is there a way that the voltage and current can be displayed for the voltmeter and ammeter for this circuit?

I'm also looking for this feature. http://www.kinder-technik.de

If this is still of interest after all this time, you might like to have a look at:

https://www.circuitlab.com/forums/feature-requests/topic/5u939uxr/voltmeter-ammeter-and-rms-values/

and:

and:

https://www.circuitlab.com/forums/support/topic/7ujceajn/how-to-use-the-volt-meter-for-plot/

hi, thanks for the reply but still no joy! i have designed a circuit with three phase supply, rectified and regulated using LM317 set at 13v and 3 darlington transistors. output voltage test is good and scope test is good, but unable to simulate the 20-60A that the circuit is designed for? I have given it a load but only registers when testing at the load node not thoughout the circuit?

please see my diagram for more info https://www.circuitlab.com/circuit/e5ench/bike-regulator-test/

sorry stuck my replies in the wrong place