Simulation should scale with source voltage

Recording current through ammeters on a frequency sweep. Result assumes a 1V source, regardless of actual voltage setting on voltage source. Would be more transparent, less error-prone, and save some user arithmetic, if the simulation considered the applied voltage.

by janszenlabs
March 16, 2023

Post a Reply

Please sign in or create an account to comment.

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.

New @ CircuitLab
DMBoie saved circuit: "Overunity - with Pin Measurement..." 8 minutes ago
cyshigue saved circuit: "JFET_Bias"
Logan221 saved circuit: "Electrospinner"
jfletch20 saved circuit: "MEST Cascade Computer Wirring"
aliasoink asked: "custom components" 20 hours ago
Elec-Girl commented on question: "Relays on a chip"
nickvi asked: "Are 510 batteries legal?"
taylorcurran answered: "Constant Current Electronic Load "
eachhabitual answered: "photocoupler"
ThaddeusHornblower answered: "Constant Current Electronic Load "
pearpermit answered: "Create your own diagram of 4 bulbs..."
Davidwalsh asked: "Relays on a chip"
zgdelima015 asked: "Create your own diagram of 4 bulbs..."
swipesy started discussion: "Resetting part auto numbering"
vanderghast commented on question: "ready-made electronic schematics..."
lsears started discussion: "45 Degree Wire"
HammerTone replied to discussion: "Increase the 10 component limit on..."
Antifreeze started discussion: "Tone Generator"
jumlouh commented on question: "level shifter 3.3V -> 12V"
maly53 commented on question: "Sine wave is 9V above expecited"
CircuitLab Blog: "Live DC Simulation!"
CircuitLab Blog: "Digital Adders and Wider Muxes"

Forums » CircuitLab Feature Requests

Simulation should scale with source voltage

Post a Reply

About CircuitLab