Bug when combining Voltage Function Generator with transformer

Hi, I am trying to simulate some 3 phase stuff, and have set up 3 Voltage Function generators with phase 0,120 and 240 degr. (50Hz 230V). When connecting 3 transformers I see that only the branch connected to the Voltage gen with phase angle = 0 works properly. This has also been confirmed with a simple circuit including only one Voltage gen, one trafo and one load resistor (100ohm). It works fine with phase angle set to 0 or 180, but not for other values.

BR JanInge

by JanInge
September 11, 2017

Post a Reply

Please sign in or create an account to comment.

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.