Angled wires

It would be very useful to have angled wires and not just angled resistors etc.

I have just set an assignment to find the effective resistance of a cube, built where each edge has a 100 ohm resistor and the PSU is connected across one edge. Very difficult to draw as a flat plan.

by andyinkuwait
October 09, 2015

Here is the actual flat plan

https://www.circuitlab.com/circuit/u567w5/3d-circuit/

by andyinkuwait
October 09, 2015

Having even 45 angled wires would make things like drawing Delta and Wye configurations much easier.

by magiman7
September 30, 2017

I agree, angled wire is very very very important!

by zhanghongce
November 02, 2017

We've been asking for this for 5 years now. Please allow wires to snap to grid points without being locked to right angles. It would allow for much cleaner diagrams.

by taedw3
April 23, 2018

Post a Reply

Please sign in or create an account to comment.

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.