Wire Crossing Setting

I know this was mentioned as a sub point in a different thread, but I thought it deserved its own thread. The bridged wire hump when wires cross can make the final schematic look less professional. This is especially the case when there are lots of crossing wires and the bridges are not even uniform in which wire crosses over which.

I understand why some users may prefer the explicit nature of wire bridges, but if you want this to make serious inroads into commercial or professional uses, the wire bridges have to go.

by magiman7
September 30, 2017

Post a Reply

Please sign in or create an account to comment.

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.