Choosing resistors for aan op-amp

Hello, so lets say i'm amplifying a 0.5Vpp 50kHz signal to a 25Vpp so the gain is 50. And my op-amp is closed loop inverting with 2 resistors, the feedback resistor and the resistor at Vin. What should my resistor values be? I know its ratio has to be 50:1 but what exactly should the values be?

by LilBoy23
July 12, 2020

You can choose anything you want within limits. The limits are overloading the opamp with too low resistance and getting the current so low that the offset is significant if the resistance is too high. You might try, say 10k input and 500k feedback but this depends very much on the opamp you're using

by Foxx
July 12, 2020

No Answers

No answers yet. Contribute your answer below!

Your Answer

You must log in or create an account (free!) to answer a question.

Log in Create an account

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

Search Questions & Answers

Ask a Question

Anyone can ask a question.

Did you already search (see above) to see if a similar question has already been answered? If you can't find the answer, you may ask a question.

About This Site

CircuitLab's Q&A site is a FREE questions and answers forum for electronics and electrical engineering students, hobbyists, and professionals.

We encourage you to use our built-in schematic & simulation software to add more detail to your questions and answers.

Acceptable Questions:

  • Concept or theory questions
  • Practical engineering questions
  • “Homework” questions
  • Software/hardware intersection
  • Best practices
  • Design choices & component selection
  • Troubleshooting

Unacceptable Questions:

  • Non-English language content
  • Non-question discussion
  • Non-electronics questions
  • Vendor-specific topics
  • Pure software questions
  • CircuitLab software support

Please respect that there are both seasoned experts and total newbies here: please be nice, be constructive, and be specific!

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.