Mouse over for values?

Every circuit I tried that had an AC voltage supply (such as rectifier/power supply ckts) wouldn't show voltage, current or power calculated values. It shows zero for everything. Not much of a circuit simulator.

by Sbeckart
September 29, 2021

Post a Reply

Please sign in or create an account to comment.

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.

New @ CircuitLab
cadams5 saved circuit: "Arduino Volt Checl" 17 minutes ago
DMBoie saved circuit: "Overunity "Proto-Circuit" - with..." 2 hours ago
mothmanup asked: "please i really need help" 2 hours ago
Hooley saved circuit: "Trigger input"
cyshigue saved circuit: "JFET_Bias"
aliasoink asked: "custom components"
Elec-Girl commented on question: "Relays on a chip"
nickvi asked: "Are 510 batteries legal?"
taylorcurran answered: "Constant Current Electronic Load "
eachhabitual answered: "photocoupler"
ThaddeusHornblower answered: "Constant Current Electronic Load "
pearpermit answered: "Create your own diagram of 4 bulbs..."
Davidwalsh asked: "Relays on a chip"
swipesy started discussion: "Resetting part auto numbering"
vanderghast commented on question: "ready-made electronic schematics..."
lsears started discussion: "45 Degree Wire"
HammerTone replied to discussion: "Increase the 10 component limit on..."
Antifreeze started discussion: "Tone Generator"
jumlouh commented on question: "level shifter 3.3V -> 12V"
maly53 commented on question: "Sine wave is 9V above expecited"
CircuitLab Blog: "Live DC Simulation!"
CircuitLab Blog: "Digital Adders and Wider Muxes"

Forums » CircuitLab Support Forum

Mouse over for values?

Post a Reply

About CircuitLab