Can’t get out of edit mode in custom part

When opening edit in custom part on an iPad you can’t get out. Only way is to start again and lose your work.

by Martbot
October 14, 2019

Post a Reply

Please sign in or create an account to comment.

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.

New @ CircuitLab
Lewis_T saved circuit: "circuit 6" 16 minutes ago
sleland saved circuit: "BE 2700 M4 final project"
evabilalovalbert answered: "Constant Current Electronic Load " 8 hours ago
cadams5 saved circuit: "Arduino Volt Checl"
HenryUni saved circuit: "10kΩ Thermistor"
vanderghast answered: "custom components"
alijen commented on question: "Getting weird results when..."
vanderghast commented on question: "What is the best battery for a..."
SuperNoob asked: "Getting weird results when..."
nickvi asked: "What is the best battery for a..."
mothmanup asked: "please i really need help"
aliasoink asked: "custom components"
Elec-Girl commented on question: "Relays on a chip"
taylorcurran answered: "Constant Current Electronic Load "
eachhabitual answered: "photocoupler"
swipesy started discussion: "Resetting part auto numbering"
lsears started discussion: "45 Degree Wire"
HammerTone replied to discussion: "Increase the 10 component limit on..."
Antifreeze started discussion: "Tone Generator"
jumlouh commented on question: "level shifter 3.3V -> 12V"
CircuitLab Blog: "Live DC Simulation!"
CircuitLab Blog: "Digital Adders and Wider Muxes"

Forums » CircuitLab Support Forum

Can’t get out of edit mode in custom part

Post a Reply

About CircuitLab