op amp output clipped to power rails

Is there a simple way to simulate an op amp with output clipped to its power rails ? I have used voltage controlled switches but results are less than desired and the schematic is not very elegant.

Thanks -

by obviousCircuits
January 16, 2017

How about a series resistor and diodes to rails?

by mikerogerswsm
January 22, 2017

Post a Reply

Please sign in or create an account to comment.

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.

New @ CircuitLab
vanderghast commented on question: "What is the best battery for a..." 5 hours ago
keiftopher saved circuit: "final project"
DMBoie saved circuit: "Over-unity "Proto-Circuit" with..."
HarmonColvett saved circuit: "Final project filter"
BrianMmari saved circuit: "Polygone"
SuperNoob asked: "Getting weird results when..." 20 hours ago
nickvi asked: "What is the best battery for a..."
mothmanup asked: "please i really need help"
aliasoink asked: "custom components"
Elec-Girl commented on question: "Relays on a chip"
taylorcurran answered: "Constant Current Electronic Load "
eachhabitual answered: "photocoupler"
ThaddeusHornblower answered: "Constant Current Electronic Load "
pearpermit answered: "Create your own diagram of 4 bulbs..."
swipesy started discussion: "Resetting part auto numbering"
lsears started discussion: "45 Degree Wire"
HammerTone replied to discussion: "Increase the 10 component limit on..."
Antifreeze started discussion: "Tone Generator"
jumlouh commented on question: "level shifter 3.3V -> 12V"
maly53 commented on question: "Sine wave is 9V above expecited"
CircuitLab Blog: "Live DC Simulation!"
CircuitLab Blog: "Digital Adders and Wider Muxes"

Forums » General Electronics Discussion

op amp output clipped to power rails

Post a Reply

About CircuitLab