Specifying LED Properties

I'm new to the simulator.

I notice that the parameters in an LED component are, to the best of my knowledge, never specified in a typical datasheet. Is there any algorithm that would allow me to map typical datasheet parameters to the LED parameters in the simulator?

Thanks.

by jrobinette
December 20, 2018

Post a Reply

Please sign in or create an account to comment.

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.

New @ CircuitLab
cadams5 saved circuit: "Arduino Volt Checl"
HenryUni saved circuit: "10kΩ Thermistor"
NDSUTeagan saved circuit: "Project2"
hmccff saved circuit: "Milestone 2"
vanderghast answered: "custom components"
alijen commented on question: "Getting weird results when..."
vanderghast commented on question: "What is the best battery for a..."
SuperNoob asked: "Getting weird results when..."
nickvi asked: "What is the best battery for a..."
mothmanup asked: "please i really need help"
aliasoink asked: "custom components"
Elec-Girl commented on question: "Relays on a chip"
taylorcurran answered: "Constant Current Electronic Load "
eachhabitual answered: "photocoupler"
ThaddeusHornblower answered: "Constant Current Electronic Load "
swipesy started discussion: "Resetting part auto numbering"
lsears started discussion: "45 Degree Wire"
HammerTone replied to discussion: "Increase the 10 component limit on..."
Antifreeze started discussion: "Tone Generator"
jumlouh commented on question: "level shifter 3.3V -> 12V"
CircuitLab Blog: "Live DC Simulation!"
CircuitLab Blog: "Digital Adders and Wider Muxes"

Forums » General Electronics Discussion

Specifying LED Properties

Post a Reply

About CircuitLab