|
|
|
| Username | thompsons2014 |
| Member Since | January 10, 2017 |
Now showing circuits 1-16 of 16. Sort by
|
|
CH10 Q1 PUBLICby thompsons2014 | updated March 23, 2017 |
|
|
OP AMP Q4 PUBLICWhen the OPAMP is inverted it shows the inverse of the normal OPAMP graph both being a triangle wave shape. by thompsons2014 | updated February 27, 2017 |
|
|
OP AMP Q5 PUBLICWhen the output is plotted for both it makes a triangle wave with the inverted OPAMP being the inverse of the normal OPAMP. by thompsons2014 | updated February 27, 2017 |
|
|
HW 4.3 Q1 PUBLICby thompsons2014 | updated February 11, 2017 |
|
|
HW 4.3 Q3 PUBLICThe voltage in for the rectifier component was the lowest out of the three while the transformer had the highest voltage out over the three. All three rectifiers made similar circuits and overlapped... by thompsons2014 | updated February 11, 2017 |
|
|
HW 4.3 Q2 PUBLICWasn't too sure about this one but I believe I did it right, the Vrms is 110 V and the frequency is 60 Hz by thompsons2014 | updated February 11, 2017 |
|
|
HW 4.3 Impedance (series and parallel) PUBLICThe impedance for series is Z= z4 + z5 + z6 and the impedance for parallel 1/Z = 1/z1 + 1/z2 + 1/z3 and the circuit to the far right is the low pass filter with a diode by thompsons2014 | updated February 11, 2017 |
|
|
Circuit Diagrams for Lab 4 PUBLICby thompsons2014 | updated February 11, 2017 |
|
|
H 3 Q 3 Differentiating Circuit PUBLICby thompsons2014 | updated February 06, 2017 |
|
|
H 3 Q 2 High Pass Filter PUBLICby thompsons2014 | updated February 06, 2017 |
|
|
HW 3 Q 1Low Pass Filter PUBLICby thompsons2014 | updated February 06, 2017 |
|
|
R-2R Thevenin Equivalent PUBLICby thompsons2014 | updated January 29, 2017 |
|
|
HW 1 Q 3 PUBLICWhen the K value is .1, .5, or 1 the output voltage was 12 volts. The voltage wasn't a straight line due to sag which would drive down the circuit. If the voltage divider was placed in the building... by thompsons2014 | updated January 23, 2017 |
|
|
HW 1 Q 2 PUBLICWhen R4 is 100 m ohms, R5 is 15 ohms, R6 is 10 k ohms the voltage across R6 is exactly 1 Volt by thompsons2014 | updated January 22, 2017 |
|
|
HW-1 Q-1 PUBLICThe voltage across R3 is 10.9 by thompsons2014 | updated January 22, 2017 |
|
|
Sean Thompson's Sample Circuit PUBLICSean Thompson's Sample Circuit by thompsons2014 | updated January 15, 2017 |