Resetting part auto numbering

Hello! I'd like to know if it's possible to reset auto part naming numbers. For example, if I add a new resistor it's named R1. The next resistor is R2. Now, let's say I delete R2, save the file and add another resistor. It's named R3 instead of the previously deleted R2. Can this be reset? Thanks!

by swipesy
March 23, 2024

Post a Reply

Please sign in or create an account to comment.

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.

New @ CircuitLab
DMBoie saved circuit: "Over-unity "Proto-Circuit" -..."
joaolbsl saved circuit: "Gate 2 p2"
Stevewill62 asked: "24 volt controller to 12 volt load" 24 hours ago
grobertson03 saved circuit: "Gilbert Cell Multiplier"
arushim saved circuit: "Spectrophotometer"
Dan.Ka started discussion: "CircuitLab example wrong?"
DFinamore commented on question: "Transformer model with CT primary..."
Foxx commented on question: "Trying to make a DIY 10000 lumen..."
plshelpadummy asked: "Trying to make a DIY 10000 lumen..."
maddiemueller asked: "oscillator wont simulate correctly"
DFinamore asked: "Transformer model with CT primary..."
vanderghast commented on an answer to: "Create your own diagram of 4 bulbs..."
danialusk commented on an answer to: "Create your own diagram of 4 bulbs..."
vanderghast answered: "custom components"
eachhabitual answered: "photocoupler"
Foxx answered: "3 phase power supply"
sgeorgia answered: "Relays on a chip"
swipesy started discussion: "Resetting part auto numbering"
lsears started discussion: "45 Degree Wire"
HammerTone replied to discussion: "Increase the 10 component limit on..."
CircuitLab Blog: "Live DC Simulation!"
CircuitLab Blog: "Digital Adders and Wider Muxes"

Forums » CircuitLab Support Forum

Resetting part auto numbering

Post a Reply

About CircuitLab