circuit for charging 4 bank of lead acid battery

need suggestion for circuit for charging 4 bank of lead acid battery wih indicators

by kumar_rishank
December 20, 2012

Need better idea of exactly what you're trying to do.

How many batteries in each bank?

Series?

Parrallel?

Battery voltage?

Indicate what?

by signality
December 20, 2012

required o/p 59V current 3A floating charge 56.2+/- 0.3V boost charge 59 +/- 0.3V series bank 48V SLA

by kumar_rishank
December 22, 2012

Have a read of:

http://www.ti.com/lit/ds/symlink/lm317.pdf

Particularly Fig 8.

But the LM317 or LM317HV is not a high enough voltage part.

This part might do:

http://www.ti.com/lit/ds/symlink/tl783.pdf

See figs 19 & 20.

To adjust outut voltage put a switch and a 2nd resistor across R11 in:

https://www.circuitlab.com/circuit/r3rtpc/lm317-test-cct-01/

Mains transformer, bridge rectifier and smoothing capacitor to get DC input to regulator.

Could do it with a SMPS but that is quite a bit more complex and - though possible - harder to simulate in CL.

by signality
December 23, 2012

https://www.circuitlab.com/editor/#6hrxd9 input is 230 V Ac , however output is not smooth, how to fix?

by kumar_rishank
December 23, 2012

Um, 230VAC with 60Hz?

Reverse D2 for “improved” rectifying ;-)

For correct simulation you have to add a signal GND at (the now floating) “sec_B” (CL’s “oscilloscope” needs a reference point).

Check your load configuration, 10uF (veeery small?) in parallel to 10mOhms?

Regards, Sancho

by Sancho_P
December 23, 2012

Post a Reply

Please sign in or create an account to comment.