Non Solid State Mixer Governor Circuit

On page 12 of this manual:

https://www.scribd.com/document/176382158/Kitchen-Aid-K45-Service-Manual-For-Hobart-Made-Vintage-Mixers

The schematic shows the center tap of the resistor connected electrically to a "T" shaped plate. When the contacts of the plate close it furnishes a direct path of current from one contact to the other through the motor with a parallel path through the resistor (180 Ohms main terminals, 90 Ohms center tap to either main terminal). When the contacts open all current must pass through the resistor. Speed regulation is accomplished by the rapid opening and closing of the contacts which rapidly places and removes the 180 Ohm resistor in series with the motor.

I know the capacitor is for spark suppression.

When the contacts are open no current can flow from the resistor center tap to the "T" Plate and when the contacts are closed far more current flows directly through them that through any pathway of the resistor.

Why is this center tap connection there?

My guess is that this center tap to the main contact plate somehow reduces the tendency for sparking but I would like a definite answer.

BTW: Old Sunbeams used the same circuit arrangement except with the no center tapped resistor.

Thanks!!

by mmdstrode
December 11, 2017

Interesting question! Yes, switching between 90 and 180 ohms would be much quieter electrically than on/off action. It would also reduce the amount of sparking and prolong the life of the contacts and the motor. A definitive answer is unlikely to surface because the designers must be long since retired.

by mikerogerswsm
December 11, 2017

Thank You!

Yes, it may be almost lost knowledge. Perhaps I can find something in an older motor control book.

by mmdstrode
December 12, 2017

Another possible reason is the tightening up of EMC regulations, which started in the US around 1950 and were strengthened in 1970ish. An on/off motor speed regulator would have created a lot of conducted and radiated noise whereas the 90/180 type would have been better. ffi: https://www.electronics-notes.com/articles/analogue_circuits/emc-emi-electromagnetic-interference-compatibility/what-is-emc-basics-tutorial.php

by mikerogerswsm
December 13, 2017

No Answers

No answers yet. Contribute your answer below!


Your Answer

You must log in or create an account (free!) to answer a question.

Log in Create an account


Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

Search Questions & Answers


Ask a Question

Anyone can ask a question.

Did you already search (see above) to see if a similar question has already been answered? If you can't find the answer, you may ask a question.


About This Site

CircuitLab's Q&A site is a FREE questions and answers forum for electronics and electrical engineering students, hobbyists, and professionals.

We encourage you to use our built-in schematic & simulation software to add more detail to your questions and answers.

Acceptable Questions:

  • Concept or theory questions
  • Practical engineering questions
  • “Homework” questions
  • Software/hardware intersection
  • Best practices
  • Design choices & component selection
  • Troubleshooting

Unacceptable Questions:

  • Non-English language content
  • Non-question discussion
  • Non-electronics questions
  • Vendor-specific topics
  • Pure software questions
  • CircuitLab software support

Please respect that there are both seasoned experts and total newbies here: please be nice, be constructive, and be specific!

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.