by chessy1991
September 07, 2018 |
|
The bridge is balanced so the 9 ohm resistor has no voltage across it and sees no current. |
by mikerogerswsm
September 07, 2018 |
explain more mathematically please... i thought that 8 ohms , and 12 ohms resistors are connected in series , and similarly the 4+6 ohms resistors .. then the whole are in parallel... |
by chessy1991
September 08, 2018 |
There is 1/3 volt across the 4 ohms and 1/3 volt across the 6 ohms. In my world 1/3 = 1/3. |
by mikerogerswsm
September 08, 2018 |
I suppose if you want a formal process you need to replace the 4 ohm and 8 ohm resistor by the Thevenin equivalent and then do the same for the 6 ohm and the 12 ohm. You really need to draw your circuit with + at the top. Having it sideways does not help conceptualisation. Hope this helps. mike |
by mikerogerswsm
September 08, 2018 |
by mikerogerswsm
September 09, 2018 |
|
Thanks a lot mike.It was helpful! |
by chessy1991
September 16, 2018 |
No answers yet. Contribute your answer below!
You must log in or create an account (free!) to answer a question.
Anyone can ask a question.
Did you already search (see above) to see if a similar question has already been answered? If you can't find the answer, you may ask a question.
CircuitLab's Q&A site is a FREE questions and answers forum for electronics and electrical engineering students, hobbyists, and professionals.
We encourage you to use our built-in schematic & simulation software to add more detail to your questions and answers.
Acceptable Questions:
Unacceptable Questions:
Please respect that there are both seasoned experts and total newbies here: please be nice, be constructive, and be specific!
CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.